How do I connect my WPS-enabled wireless router to my product?

  • See below.

    Using WPS to Connect to a Network

    If you have a WPS-enabled router or access point, you can use Wi-Fi Protected Setup (WPS) to connect your device to the network.

    Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access point. If there is no hardware button, there may be a virtual WPS button in the software for the device. Check your network product documentation for details.

    1. To connect to a WPS-enabled router, press the WPS button on your router or access point.
    2. Press and hold down the Wi-Fi button on your product for 3 seconds. The  Wi-Fi and  Wi-Fi Direct lights flash alternately. When the  Wi-Fi light stays on, the connection is successful.

      Note: Be sure to press and hold the Wi-Fi button on your product within 2 minutes of pressing the WPS button on your router or access point.

    If the  Wi-Fi and  Wi-Fi Direct lights flash simultaneously, there is a connection error. Press the Wi-Fi button, restart your router, move it closer to your product, and repeat the steps here to try again.

    Related Concepts
    Control Panel Buttons and Lights
Published:  Mar 29, 2018 Was this helpful? Thank you for the feedback!
Was this helpful?
Please tell us why this was not helpful.