How do I connect my product with a Wi-Fi Direct connection?

• See below.

  Enabling Wi-Fi Direct Mode

  You can enable Wi-Fi Direct mode to allow direct communication between your product and computer or other devices without a wireless router or access point.
  1. Press the  home button, if necessary.
  2. Press the arrow buttons to select Wi-Fi Setup and press the OK button. You see this screen:
     
     
  3. Press the arrow buttons to select Wi-Fi Direct Setup and press the OK button.
  4. Press the arrow buttons to select Connection Setup and press the OK button.
  5. Press the down arrow button, then press the OK button to change the Wi-Fi Direct password.

     Note: If you have already connected devices or computers to your product via Wi-Fi Direct, they will be disconnected when you change the password.

  6. Enter your Wi-Fi Direct password.

     Note: Your password must be at least 8 and no more than 22 characters long.

     
     
     
     • Press the up and down arrow buttons to scroll through characters. Then press the right arrow button to move to the next character.
     • To switch between ABC (uppercase), abc (lowercase), or 123 (numbers and symbols), press the  home button.
     • To delete characters, press the left arrow.
     • When you finish entering characters, press the OK button.
  7. Press the OK button. You see a screen like this:
     
     
  8. Use your computer or wireless device to select the Wi-Fi network name (SSID) displayed on the LCD screen, then enter the password shown.
  9. Press the OK button to exit. You see either an AP or D connection symbol on the LCD screen and should be able to connect to your product directly from your computer or device, and then print. If you are printing from a computer, make sure you installed the network software as described on the Start Here sheet.

     Note: Make a note of the SSID and password that appear.

     If the AP or D connection symbol is not displayed on the LCD screen, Wi-Fi Direct mode is not enabled. Repeat these steps to try again.