How do I connect my product with a Wi-Fi Direct connection?

• See below.

  Enabling Wi-Fi Direct Mode

  You can enable Wi-Fi Direct mode to allow direct communication between your product and computer or other devices without a wireless router or access point.

  Note: If you are printing from a computer, make sure you installed the network software as described on the Start Here sheet.

  1. Press the  home button, if necessary.
  2. Press the arrow buttons to select Wi-Fi Setup and press the OK button. You see this screen:
     
     
  3. Press the right arrow button to select Wi-Fi Direct and press the OK button.
  4. Press the OK button twice. You see this screen:
     
     
  5. Press the down arrow button and then press the arrow buttons to select Change Password.
  6. Press the OK button.
  7. Press the OK button to change the Wi-Fi Direct password.

     Note: If you have already connected devices or computers to your product via Wi-Fi Direct, they will be disconnected when you change the password.

  8. Enter your Wi-Fi Direct password.

     Note: Your password must be at least 8 and no more than 22 characters long.

     
     
     
     • To enter characters, press the buttons on the numeric keypad.
     • To change the character case or type, press the  reset button.
     • To move the cursor to the right or to add a space, press the right arrow button.
     • To move the cursor to the left, press the left arrow button.
     • To enter symbols, press 1 on the numeric keypad.
     • To delete the previous character, press the  stop button.
     • To delete all the characters, press the C clear button.
     • When you finish entering characters, press the OK button.
  9. Press the OK button.

     Note: Make a note of the SSID and password that appear.

  10. Use your computer or wireless device to select the Wi-Fi network name (SSID) displayed on the LCD screen, then press the OK button.
  11. Use your computer or wireless device to enter the password displayed on the LCD screen.
  12. Press the OK button twice to exit. You see the icon on the LCD screen and should be able to connect to your product directly from your computer or device, and then print.

      Note: If the icon is displayed on the LCD screen, Wi-Fi Direct mode is not enabled. Repeat these steps to try again.