I see static or noise in the image. What should I do?

• Check the following:
  • If you're using a computer cable longer than 6 feet (2 meters), or an extension cable, the image quality may be reduced.
  • If you're using an extension cable, you may pick up interference if the cable is not adequately shielded. You may need to use a signal amplifier for longer cables.
  • Keep your computer and video cables separated from the power cord as much as possible to prevent interference.
  • The video signal may be split between the computer and the projector. If you notice a decline in the projected image quality when the image is displayed simultaneously on your laptop computer and the projector, turn off the laptop's LCD display.
  • If you're projecting from a composite or S-Video source, check the Video Signal setting in the Signal menu. In most cases, leave it set to Auto. If you're using a 60-Hz PAL video source, change this setting to PAL60. See Adjusting the Input Signal.
  • Make sure the cables are securely connected at both ends.
  • Select the correct resolution. See Compatible Video Formats.
  • If you're projecting from a computer, press the Enter/Auto button on the remote control or the Enter button on the projector to adjust tracking and sync automatically. If that doesn't work, try adjusting the Sync and Tracking settings in the Signal menu. See Adjusting the Input Signal.
  • Be sure the Progressive setting is set to On in the Signal menu. See Adjusting the Input Signal.
  • If the DVD player has a component video port, you can use a component-to-VGA video cable to connect your DVD player to the projector's Computer1 or Computer2 port. You can purchase a component-to-VGA video cable (part number ELPKC19) from the Epson Store.