When and how should I clean or replace the air filter?

• See below.

  Cleaning the Air Filter and Vents

  Clean the projector's air filter or vents if they get dusty, or if you see a message telling you to clean them. It is recommended that you clean these parts at least once every three months, or more often if you use the projector in an environment that is dustier than expected.

  Caution:
  Do not use water or any detergent to clean the air filter. Do not use canned air, or the gases may leave a flammable residue.

  1. Turn off the projector and unplug the power cord.
  2. Slide the air filter cover latch and open the air filter cover.
     
     
  3. Pull the air filter out of the projector.
     
     
  4. Vacuum the front of the air filter (the side with the tabs) to remove any remaining dust.

     Caution:
     Do not rinse the air filter in water, or use any detergent or solvent to clean it. Do not use canned air; the gases may leave a flammable residue, or push dust and debris into the projector's optics or other sensitive areas.

     Note: If dust is difficult to remove or the air filter is damaged, replace the air filter.

  5. Place the air filter back in the projector with the four tabs facing down as shown.
     
     
  6. Close the air filter cover until it clicks into place.

     Caution:
     Do not try to force the air filter cover closed if the tabs of the air filter are facing up. You could damage the projector.

  Related tasks
  Turning Off the Projector
  Related references
  Optional Equipment and Replacement Parts
  

  Replacing the Air Filter

  You need to replace the air filter in the following situations:
  • After cleaning the air filter, you see a message telling you to clean or replace it
  • The air filter is torn or damaged

  You can replace the air filter while the projector is placed on a table.

  1. Turn off the projector and unplug the power cord.
  2. Slide the air filter cover latch and open the air filter cover.
     
     
  3. Pull the air filter out of the projector.
     
     

     Note: Air filters contain polypropylene. Dispose of used air filters according to local regulations.

  4. Place the new air filter in the projector as shown (with the four tabs facing down).
     
     
  5. Close the air filter cover and press until it clicks into place.

     Caution:
     Do not try to force the air filter cover closed if the tabs of the air filter are facing up. You could damage the projector.

  Related references
  Optional Equipment and Replacement Parts